江苏春晨电缆有限公司生产春晨JG电机引接线 JG电机引出线，春晨JG电机引接线 JG电机引出线，上图为带补偿式单相交流稳压器原理图.主要由调压变压器T1和补偿变压器T2组成.从图中可以看出,补偿变压器的低压侧线圈串联在稳压器的主回路中,那么,这种稳压器输出的主要能量是通过补偿变压器的低压侧线圈直接加给输出负载的.只要把补偿变压器的二次线圈的线径作得足够大,稳压器的功率就可以做得很大.调压变压器T1只要负担输入电压与输出电压的差额部分,按稳压器可允许的输入变化范围的大小不等,调压变压器T1的功率大小往往是稳压器实际容量的几分之一,这由稳压器的配比这个参数来决定调压变压器的大小.

The above figure is the schematic diagram of single-phase AC voltage regulator with compensation. It is mainly composed of voltage regulating transformer T1 and compensation transformer T2. It can be seen from the figure that the low-voltage side coil of compensation transformer is connected in series with the main circuit of the voltage regulator, so, The main output energy of the voltage regulator is directly added to the output load through the low-voltage side coil of the compensation transformer. As long as the wire diameter of the secondary coil of the compensation transformer is made large enough, the power of the voltage regulator can be made large. As long as the difference between the input voltage and the output voltage is borne by the voltage regulator T1, the allowable input change range is not the same, The power of the voltage regulating transformer T1 is often a fraction of the actual capacity of the voltage regulator, which is determined by the ratio of the voltage regulator

下面我们分析它的工作原理:

Let's analyze how it works:

调压变压器主要担任提供补偿电压,这个补偿电压的大小和方向根据调压变压器的滑臂的移动都是可以改变的,这就可以在补偿变压器的低压侧得到大小和方向都可以改变的补偿电压,这个电压会和输入端提供的电压进行矢量叠加.使输出电压稳定在所需要的设置点上.

The voltage regulating transformer is mainly used to provide the compensation voltage. The size and direction of the compensation voltage can be changed according to the movement of the sliding arm of the voltage regulating transformer, so that the compensation voltage with the size and direction can be changed at the low-voltage side of the compensation transformer can be obtained. The voltage will be vector superposition with the voltage provided by the input end, so as to stabilize the output voltage at the required set point