现浇雨水检查井模具因为体型比较大一般采用5mm厚的钢板加工制成6*8mm厚度的肋筋加固，这么做的目的是为了防止井体模具变形破损。一套井体钢模具包括内模、外模、连接孔、收口、上盖模具。现浇雨水检查井模具使用方法：首先将井体钢模具内腔喷一层机油，为了脱模方便，在内外模中间放入钢筋网，然后将搅拌好的混凝土注入模具中，振动棒振捣，等混凝土初期凝固便可拆模，约24小时左右。The cast-in-situ rainwater inspection well mold, also known as well body steel mold, is a steel mold used to produce cement well body. This mold is divided into cast-in-situ type and prefabricated type. The cast-in-situ rainwater inspection well mold is a way to lift the steel mold into the well construction site for installation and cement pouring on site, and disassemble the mold after the setting time, so as to achieve the well construction. The prefabricated cement well body mold is to splice the steel mold in the cement Prefabrication Yard, then pour the cement into the vibration and wait for demoulding. After 24 hours of cement solidification, disassemble the mold to obtain the prepared cement well body, and then transport the cement well body to the construction site for installation.

Because the cast-in-situ rainwater inspection well mold is relatively large, it is generally processed with 5mm thick steel plate and reinforced with 6 * 8mm thick ribs. The purpose of this is to prevent the well mold from deformation and damage. A set of well body steel mould includes inner mould, outer mould, connecting hole, closing and upper cover mould. Application method of cast-in-situ rainwater inspection well mold: firstly, spray a layer of engine oil into the inner cavity of the well steel mold. In order to facilitate demoulding, put reinforcement mesh in the middle of the inner and outer mold, then inject the mixed concrete into the mold, vibrate with a vibrating rod, and remove the mold after the initial solidification of the concrete, about 24 hours.